Rockwell Automation 2711-ND3 PanelBuilder32 Quick Start Manual - Manual (Page 65)

Publication 2711-QS003D-EN-P - June 2009 65
Entering Application Tags Chapter 5
ControlNet Unscheduled Application Tags
The table shows application tags used by the ControlNet application
using unscheduled messaging. Tags are shown for a ControlLogix
application. Defaults are accepted for fields not shown in table.
ControlNet Scheduled Application Tags
The table shows application tags used by the ControlNet application
using scheduled messaging. Defaults are accepted for fields not
shown in table.
Tag Name Data Type Tag Address Description
Node
Name Initial
Value
Min Max
Start_Motor Bit Motor_Control.00 Starts the motor LC_1 0 0 0
Stop_Motor Bit Motor_Control.01 Stops the motor LC_1 0 0 0
Motor_Status_Ind Bit Motor_Control.02 Shows on/off
motor status LC_1 0 0 0
Motor_Speed Signed
Integer/INT Motor_Speed[0] Shows the motor
speed LC_1 0 0 65535
Set_Max_Motor_Speed Signed
Integer/INT Motor_Speed[1] Sets the maximum
speed LC_1 1800 600 1800
Speed_Alarm Bit Alarms.00 Triggers alarm
messages LC_1 0 0 0
Tag Name
Data Type
Tag
Address
Description Node Name
Initial
Value
Min Max
Start_Motor Bit S I 0:0/0 Starts the
motor ControlNet_Scheduled_
File 0 0 0
Stop_Motor Bit S I 0:0/1 Stops the
motor ControlNet_Scheduled_
File 0 0 0
Motor_Status_Ind Bit SO0:0/0 Shows on/off
motor status ControlNet_Scheduled_
File 0 0 0
Motor_Speed Signed
Integer/INT SO0:1 Shows the
motor speed ControlNet_Scheduled_
File 0 0 65535
Set_Max_Motor_Speed Signed
Integer/INT S I 0:1 Sets the
maximum
speed ControlNet_Scheduled_
File 1800 600 1800
Speed_Alarm Bit SO0:2/0 Triggers alarm
messages ControlNet_Scheduled_
File 0 0 0