Rockwell Automation 2711-ND3 PanelBuilder32 Quick Start Manual - Manual (Page 60)

60 Publication 2711-QS003D-EN-P - June 2009
Chapter 4 Configuring Communication
Configure ControlNet
Communication This section defines the communication settings for a ControlNet
PanelView terminal and ControlLogix controller on a ControlNet
network.
1. Select Application>Settings.
2. On the Terminal Setup tab, click the Comms. Setup button.
Set the properties as shown.
3. Click OK until you exit the Application Settings dialog.
Verify that the catalog number and firmware
number matches your hardware.
1 for Allen-Bradley PLC
1 1 0 for ControlLogix, where:
1 refers to the 1784-CNB node number (1 to 99)
1 refers to the ControlLogix backplane number
0 refers to ControlLogix slot number
You must enter a space between the numbers as shown.
Important: LC_1 is entered
to match the Node name in
the Tag Editor. Select the logic controller
you are using.