Rockwell Automation 2711-ND3 PanelBuilder32 Quick Start Manual - Manual (Page 62)

62 Publication 2711-QS003D-EN-P - June 2009
Chapter 4 Configuring Communication
Configure DF1
Communication This section defines the communication settings for a DF1 PanelView
terminal and a PLC-5 or SLC 5/03, /04, /05 controller through
channel 0.
1. Select Application>Settings.
2. On the Terminal Setup tab, click the Comms. Setup button.
Set the properties as shown.
3. Click OK until you exit the Application Settings dialog.
Save the application Select File>Save or click the Save tool on the toolbar.
Important: LC_1 is entered to
match the Node name in the
Tag Editor. Select the logic controller you
are using.
Verify that the catalog number and firmware
number matches your hardware.