Rockwell Automation 2711-ND3 PanelBuilder32 Quick Start Manual - Manual (Page 17)

Publication 2711-QS003D-EN-P - June 2009 17
System Setup Chapter 1
RS-232 Connections
(DH-485 Protocol) RS-232 (DH485) versions of the PanelView terminal are available with
one or two RS-232 ports. On terminals with two RS-232 ports, one of
the ports is a printer port. The other RS-232 communication port is for
connection to an SLC or computer.
Serial Port
COM1 or COM2
Cable
2711-NC13, 2711-NC14,
2706-NC13
Node 2
PanelView 1000
RS-232 Terminal Shown
Node 0
Personal Computer
PanelBuilder32 Software
Node 1
SLC 5/03, /04, /05 Controller,
CompactLogix, or MicroLogix 1500LRP
Use the same cable to transfer applications to the terminal and to the SLC 5/03, 5/04, 5/05
controller. Change cable connection to controller after downloading.
MicroLogix 1000 Controller
To Channel 0
DF1 Port
1761-CBL-HM02
AIC+
1761-NET-AIC
IMPORTANT
You must configure the Channel 0 Port of the SLC 5/03, 5/04,
5/05 or MicroLogix controller for DH-485 communication using
APS, AI500 or RSLogix 500 programming software.