Rockwell Automation 2711-ND3 PanelBuilder32 Quick Start Manual - Manual (Page 68)

68 Publication 2711-QS003D-EN-P - June 2009
Chapter 5 Entering Application Tags
6. Double-click in the Description field and type Starts the Motor.
7. Click on the arrow in the Node Name field and select LC_1.
This node name was entered for the logic controller when you
defined communication settings.
The defaults are accepted for the rest of the tag attributes.
However, for the Set_Max_Motor_Speed tag enter 600 in the
Minimum field, and 1800 in the Initial Value and Maximum
fields.
8. Repeat steps 2 through 7 to enter the rest of the tags.
The tag editor should look similar to this when you are done
entering your tags.
9. Save the tags by selecting File>Save Project.
10. Close the tag editor by clicking the X in the title bar.
11. Close each screen by clicking the X in the title bar of the screen.
Or select Screen>Close to close each screen.
Save the Application Select File>Save or click the Save icon on the toolbar.