Rockwell Automation 2711-ND3 PanelBuilder32 Quick Start Manual - Manual (Page 66)

66 Publication 2711-QS003D-EN-P - June 2009
Chapter 5 Entering Application Tags
DeviceNet Application Tags
The table shows application tags used by the DeviceNet application.
Defaults are accepted for fields not shown in table.
EtherNet/IP Application Tags
The table shows application tags used by the ControlLogix controller
in the EtherNet/IP application using controller addressing. Defaults
are accepted for fields not shown in table.
Tag Name Data Type
Tag
Address
Description
Node
Name Initial
Value
Min Max
Start_Motor Bit I :00/0 Starts the motor LC_1 0 0 0
Stop_Motor Bit I :00/1 Stops the motor LC_1 0 0 0
Motor_Status_Ind Bit O:0/0 Shows on/off motor status LC_1 0 0 0
Motor_Speed Unsigned
Integer O:1 Shows the motor speed LC_1 0 0 65535
Set_Max_Motor_Speed Unsigned
Integer I :1 Sets the maximum speed LC_1 1800 600 1800
Speed_Alarm Bit O:2/0 Triggers alarm messages LC_1 0 0 0
Tag Name Data Type Tag Address Description
Node
Name Initial
Value
Min Max
Start_Motor Bit Motor_Control.00 Starts the motor LC_1 0 0 0
Stop_Motor Bit Motor_Control.01 Stops the motor LC_1 0 0 0
Motor_Status_Ind Bit Motor_Control.02 Shows on/off
motor status LC_1 0 0 0
Motor_Speed Signed
Integer/INT Motor_Speed[0] Shows the motor
speed LC_1 0 0 65535
Set_Max_Motor_Speed Signed
Integer/INT Motor_Speed[1] Sets the maximum
speed LC_1 1800 600 1800
Speed_Alarm Bit Alarms.00 Triggers alarm
messages LC_1 0 0 0