Rockwell Automation 2711-ND3 PanelBuilder32 Quick Start Manual - Manual (Page 56)

56 Publication 2711-QS003D-EN-P - June 2009
Chapter 4 Configuring Communication
Configure DH-485
Communication This section defines the communication settings for a DH-485
PanelView terminal and logic controller on a DH-485 network.
1. Select Application>Settings.
2. Select the Terminal Setup tab.
3. Click the Comms. Setup button and set the parameters as
shown.
To add a network node, right-click the Node Name field. Enter
the Node Name, Node Address and Node Type for the controller
you are using.
4. Click OK until you exit the Application Settings dialog.
Important: Make sure
the catalog number and
firmware number match
your terminal.
Select the logic controller
you are using. Important: LC_1 is entered to
match the Node name in the
Tag Editor.