Rockwell Automation 2711-ND3 PanelBuilder32 Quick Start Manual - Manual (Page 57)

Publication 2711-QS003D-EN-P - June 2009 57
Configuring Communication Chapter 4
Configure DH+
Communication This section defines the communication settings for a DH+ PanelView
terminal and logic controller on a DH+ network.
1. Select Application>Settings.
2. Select the Terminal Setup tab.
3. Click the Comms. Setup button.
4. Set the parameters as shown.
To add a network node, right-click on the Node Name field.
Enter the Node Name, Node Address and Node Type of the
logic controller you are using.
5. Click OK until you exit the Application Settings dialog.
IMPORTANT
For ControlLogix controller, select a PLC-5 as the Node Type.
Important: LC_1 is entered to
match the Node name in the Tag
Editor.
Check the firmware number to make sure
it matches your hardware.
Select the logic controller
you are using.