Rockwell Automation 2711-ND3 PanelBuilder32 Quick Start Manual - Manual (Page 12)

12 Publication 2711-QS003D-EN-P - June 2009
Preface
Communication Cables
DH-485 PanelView Terminals - To connect a PanelView DH-485
port to a DH-485 connector on an SLC controller, use a 1747-C10,
-C11, or -C20 DH-485 cable.
RS-232 (DF1 or DH485) PanelView Terminals - To connect a
PanelView RS-232/DF1 or DH485 communication port to an RS-232
port on a controller, use a 2706-NC13, 2711-NC13, or 2711-NC14
cable. To connect to the 8-pin RS-232 port on the MicroLogix
1000/1200/1500LSP controller, use a 2711-NC21 or -NC22 cable.
Refer to the AIC+ Advanced Interface Converter User Manual,
publication
1761-UM004 , for additional network configurations.
For the 300 Micro terminal, use a 2711-CBL-HM05, -HM10, -PM05, or
-PM10 cable.
Remote I/O Terminals - To connect the PanelView RIO port to an
RIO port on a PLC controller, use the 1770-CD cable, equivalent to
Belden 9463.
DH + PanelView Terminals - To connect the PanelView DH+ port to
a DH+ port on a PLC controller, use the 1770-CD cable, equivalent to
Belden 9463.
ControlNet Terminals - To connect the PanelView terminal to a
ControlNet network, use coaxial cable 1786-CP.
EtherNet/IP Terminals - To connect the PanelView terminal to an
EtherNet/IP network, use a Category 5 shielded and unshielded
twisted-pair cable with RJ45 connectors.
DeviceNet Terminals -To connect the PanelView terminal to a
DeviceNet network, use a 1485C-P1A50, -P1A150, or -P1A300 cable.
Refer to the AIC+ Advanced Interface Converter User Manual,
publication
1761-UM004 , for additional network configurations.