Rockwell Automation 2711-ND3 PanelBuilder32 Quick Start Manual - Manual (Page 25)

25 Publication 2711-QS003D-EN-P - June 2009 25
Chapter
2
Overview of Application
This chapter covers:
•
purpose of application
•
overview of application screens
•
application tags
Purpose of Application The application contains objects that control and monitor the status of
a motor. The PanelView terminal reads/writes data to a specific
controller based on the communication protocol.
•
SLC, MicroLogix, FlexLogix, or CompactLogix controller on a
DH-485 network
•
SLC, PLC-5, or ControlLogix controller on a DH+ network
•
SLC, PLC-5 or ControlLogix controller on a Remote I/O network
•
SLC, PLC-5, MicroLogix, FlexLogix, CompactLogix, or
ControlLogix controller on an RS-232 (DF1) network
•
ControlLogix, PLC-5, or SLC controller on a DeviceNet network
•
ControlLogix or PLC-5C controller on a ControlNet network
(unscheduled)
•
ControlLogix controller on a ControlNet network (scheduled)
•
ControlLogix, PLC-5E, or SLC 5/05 controller on an EtherNet/IP
network
Chapter 4, Configuring Communication, gives procedures for creating
the application on a PanelView 600 keypad terminal.
•
If creating the application for a touch screen terminal, touch cell
input is automatically enabled and you do not have to assign
function keys.
•
If creating the application for other size terminals, use the
appropriate text sizes.
You can create any of the sample applications for another PanelView
terminal size. For instructions on how to do this, see page
53 .
All of the sample applications are on the installation CD in the
\QuickStart\PV directory.