Rockwell Automation RECOMM-PBUS PROFIBUS Communications Module - Manual (Page 17)

Installing the PROFIBUS Module 3-1
C
HAPTER
3
Installing the
PROFIBUS Module
Chapter 3 provides instructions for installing the PROFIBUS module
in an SP600 drive.
3.1 Preparing for an Installation
Before installing the PROFIBUS module, verify that you have all
required equipment. Refer to chapter 2, Getting Started.
3.2 Commissioning the Module
To commission the module, you must set a unique node address.
(Refer to the Glossary for details about node addresses.)
Important: New settings are recognized only when power is
applied to the module. If you change a setting, cycle
power.
Step 1. Set the node address switches as shown in figure 3.1.
!
ATTENTION: The PROFIBUS module contains
ESD- (Electrostatic Discharge) sensitive parts that
can be damaged if you do not follow ESD control
procedures. Static control precautions are required
when handling the module. Failure to observe these
precautions could result in damage to equipment.