Rockwell Automation RECOMM-PBUS PROFIBUS Communications Module - Manual (Page 38)

5-6 PROFIBUS Communications Module
Step 4. A user-defined Name and Description can be given to
the scanner. In our example, the scanner will be Station 0
on the network, as shown in figure 5.7.
Step 5. Click on the Parameters tab to view the Scan Cycle
Times.
In our example, use the default settings as shown in
figure 5.8.
Connection and Baud Rate settings configure how the software tool
will communicate with the CONFIG RS232 port on the scanner.
Step 6. Click on the COM Port tab.
Figure 5.7 – SST-SST-PFB-SLC Master (General) Dialog Box
Figure 5.8 – Scan Cycle Times Dialog Box