Rockwell Automation RECOMM-PBUS PROFIBUS Communications Module - Manual (Page 50)

5-18 PROFIBUS Communications Module
Important: The processor needs to be in program mode before
proceeding.
Step 32. Right-click on the scanner in the network window and
select “Connect”. Then right-click again on the scanner in
the network window and select “Load Configuration”. If a
minimum cycle time attention window pops up, click OK
to continue. After the configuration has been loaded into
the scanner, “Configured Program” will be displayed in the
message window (see figure 5.32).
Step 33. Click File and Save As from the tool bar, as a unique File
Name. The configuration of the scanner is now complete.
Note that cycling power to the scanner is recommended.
See figure 5.33.
Figure 5.32 – Network Window Scanner Selection
Figure 5.33 – Save As Dialog Window
[001]_RECOMM_PBUS(**)
[002]_RECOMM_PBUS(**)