Rockwell Automation FactoryTalk Historian SE 4.0 Installation and Configuration Guide - Manual (Page 102)

Chapter 5 Configuring FactoryTalk Historian
102 Rockwell Automation Publication HSE-IN025A-EN-E–September 2013
NOTE
Use the Windows File System Compression feature with caution; it
might slow down the access of the Historian server to archive files. The
compression can save disk space, but it requires more CPU resources.
NOTE
You need administrative rights to perform these steps.
To restart the server:
1. Stop the server:
1. Go to Start > All Programs > Rockwell Software >
FactoryTalk Historian SE.
2. Right-click Stop FactoryTalk Historian SE, and then
select Run as administrator.
The server stopping process begins. The progress is
displayed in the Command Prompt window.
3. Wait until the server is stopped and the Command Prompt
window is closed.
2. Start the server:
1. Go to Start > All Programs > Rockwell Software >
FactoryTalk Historian SE.
2. Right-click Start FactoryTalk Historian SE, and then
select Run as administrator.
The server starting process begins. The progress is displayed
in the Command Prompt window.
3. Wait until the server is started and the Command Prompt
window is closed.
Restarting FactoryTalk
Historian SE Server