Rockwell Automation FactoryTalk Historian SE 4.0 Installation and Configuration Guide - Manual (Page 41)

Installing FactoryTalk Historian Chapter 3
Rockwell Automation Publication HSE-IN025A-EN-E–September 2013 41
wizard page, and you will be prompted to restart the machine
after the installation wizard closes.
15. Click Finish to exit the installation wizard.
16. Restart the computer.
The FactoryTalk Historian Management Tools are installed
automatically as a part of the FactoryTalk Historian SE installation.
This option allows you to install just the Management Tools on a
non-FactoryTalk Historian Server computer, typically a FactoryTalk
View SE client computer or a remote computer, from which you can
perform administrative tasks.
The FactoryTalk Historian Management Tools are installed with
the following FactoryTalk Historian components:
• PI Software Development Kit (PI SDK)
• Interface Configuration Utility (ICU)
• FactoryTalk Historian SE RA Components
• MS Runtime Redistributables
To install the FactoryTalk Historian Management Tools:
1. Run the FactoryTalk Historian SE installation DVD.
2. On the welcome page of the installation wizard, click
Install
FactoryTalk Historian Site Edition > Install FactoryTalk
Historian Management Tools.
The installation wizard appears.
If there are any software prerequisites missing from the
computer or services that must be stopped, they are listed in
red at the bottom of the installation wizard Welcome page.
Click Cancel, and then Finish to exit the wizard, install the
prerequisites and/or stop the services, and then start the
installation wizard again.
Install FactoryTalk Historian
Management Tools
(Optional)