Rockwell Automation FactoryTalk Historian SE 4.0 Installation and Configuration Guide - Manual (Page 27)

Installing FactoryTalk Historian Chapter 3
Rockwell Automation Publication HSE-IN025A-EN-E–September 2013 27
To install RSLinx Enterprise:
1. Run the FactoryTalk Historian SE installation DVD.
2. On the welcome page of the installation wizard, click
Install
FactoryTalk Historian Site Edition > Install RSLinx Enterprise.
The system checks if you have all the required components
installed. If any components are missing, a dialog box appears
prompting you to install the missing components.
3. Click OK.
The installation wizard appears.
4. On the Welcome page, click Next.
5. On the License Agreement page, read and accept the terms of
the license agreement, selecting the I accept... option.
6. Click Next.
7. On the Setup Type page, select Standard Feature Set
Installation, and then click Next.
8. On the Ready to Install the Program page, click Install to
start the installation.
The Installing... page appears with the status of the
installation.
9. In the Windows Security dialog box, select Always trust
software from "Rockwell Automation", and click Install to
proceed with the installation of the software.
10. On the InstallShield Wizard Completed page:
• Clear the check box next to Review Release Notes, if you
do not want to have them displayed.
• Click Finish to exit the wizard.