Rockwell Automation FactoryTalk Historian SE 4.0 Installation and Configuration Guide - Manual (Page 24)

Chapter 3 Installing FactoryTalk Historian
24 Rockwell Automation Publication HSE-IN025A-EN-E–September 2013
The system checks if you have all the required components
installed. If any components are missing, a dialog box appears
prompting you to install the missing components.
Click Install to install the components.
The installation wizard appears.
3. On the Welcome... page, click Next.
4. On the License Agreement page, read and accept the terms of
the license agreement, selecting the I accept... option.
5. Click Next.
6. On the Setup Type page, select Standard, and then click
Next.
7. On the Ready to Install the Program page, click Install to
start the installation.
The Installing page appears with the status of the installation.
8. On the InstallShield Wizard Completed page, click Finish
to exit the wizard.
You may be prompted to restart your computer to complete
the installation. If you do not choose to restart your computer
at this time, be sure to restart it at the completion of the
required installation steps for FactoryTalk Historian SE.
This configuration points your client computer to the FactoryTalk
Directory server computer. Once your computer is connected to the
FactoryTalk Directory server, you can use the client computer to
administer the Network directory on the FactoryTalk Directory
server computer. Also, the FactoryTalk Administration Console
window on your client computer reflects the content of the
Network Directory server computer.
Specify FactoryTalk Directory
Server Location