Rockwell Automation FactoryTalk Historian SE 4.0 Installation and Configuration Guide - Manual (Page 90)

Chapter 5 Configuring FactoryTalk Historian
90 Rockwell Automation Publication HSE-IN025A-EN-E–September 2013
For either of the two limit checks the following message is
displayed:
NOTE
The following license activations are excluded from the point
limit check: AVIEW, FTBAInt, FHSE.H2H, FHSE.Advanced,
FHSE.OLEDB, and FHSE.OPC.
7. Click Apply.
If you have assigned more license activations than you
currently have available, the following message appears:
Change the number of the license activations, and then click
Apply again.
By allocating a license to an interface type (or point source), you
specify the maximum number of points with which the server will
collect data from a given interface type (or point source).
To allocate licenses to interface types:
1. In the Historian Server Connection Properties dialog box,
click the Point Sources tab.
Allocating Licenses to
Interface Types