Rockwell Automation FactoryTalk Historian SE 4.0 Installation and Configuration Guide - Manual (Page 80)

Chapter 5 Configuring FactoryTalk Historian
80 Rockwell Automation Publication HSE-IN025A-EN-E–September 2013
4. Right-click FTLD1, and select Properties. The Data
Collection Interface Properties dialog box appears.
5. Go to the General tab, and verify in the Service Status section
that the Startup Type is set to Automatic.
6. To start the data collection service, click Start and wait until
the service status changes to Started. For more information,
click the help icon in the dialog box.
7. Click OK to close the dialog box.
Once you have your activations, you can assign them to your
Historian server, and allocate tag counts to selected interface types
(or point sources).
See the following topics for more information:
• Types of Licenses (page 80)
• Using the General License Pool (page 83)
• Assigning License Activations to FactoryTalk Historian SE
Server (page 88)
• Allocating Licenses to Interface Types (page 90)
• Viewing Allocated Licenses (page 93)
The license activations you get for your Historian server are various
types of licenses that you can use in either of the following pools of
licenses:
• Rockwell
Groups license activations for Rockwell sources only.
• General
Groups license activations for tags from both Rockwell and
third-party devices.
Managing Licenses
Types of Licenses