Rockwell Automation FactoryTalk Historian SE 4.0 Installation and Configuration Guide - Manual (Page 84)

Chapter 5 Configuring FactoryTalk Historian
84 Rockwell Automation Publication HSE-IN025A-EN-E–September 2013
To calculate the distribution of licenses between the General
and Rockwell license pools:
1. Calculate the <BaseLicenseCount> value.
It is an intermediate value that will be used to calculate your
number of licenses of the General pool.
• If you use FHSE3ADD license activations, take the number
of your FHSE license activations and substitute it into the
following equation:
<BaseLicenseCount> = 20% * ∑ <FHSE licenses>
See "Distributing Licenses with FHSE3ADD Activation
(page 85)" for details.
• If you do not use FHSE3ADD license activations, take the
number of your FHSE license activations and substitute it
into the following equation:
<BaseLicenseCount> = Max (Min(1000, ∑ <FHSE
licenses>), 20% * ∑ <FHSE licenses>)
See "Distributing Licenses without FHSE3ADD Activation
(page 86)" for details.
2. Calculate the number of licenses for the Rockwell license pool.
Take the number of your FHLD licenses, FHSE licenses, and
the <BaseLicenseCount> value, and then substitute them into
the following equation:
<RockwellLicensePool> = ∑ <FHLD licenses> + ∑ <FHSE
licenses> - <BaseLicenseCount>
3. Calculate the number of licenses for the General license pool.
Take the number of your PTY3 licenses, the FHSE3ADD
licenses, and the <BaseLicenseCount> value, and then
substitute them into the following equation:
<GeneralLicensePool> = ∑ <PTY3 licenses> +
<BaseLicenseCount> + ∑ <FHSE3ADD licenses>