Rockwell Automation FactoryTalk Historian SE 4.0 Installation and Configuration Guide - Manual (Page 35)

Installing FactoryTalk Historian Chapter 3
Rockwell Automation Publication HSE-IN025A-EN-E–September 2013 35
• RA Components
• FactoryTalk Activation Manager
NOTE
The FactoryTalk Historian SE Server must be installed on Microsoft
Windows Server 2008 R2 with Service Pack 1 64-bit. If you try to
install it on any other operating system, the message presented
below will appear and the installation will be aborted.
To install the FactoryTalk Historian SE server:
1. Run the FactoryTalk Historian SE installation DVD.
2. On the welcome page of the installation wizard, click
Install
FactoryTalk Historian Site Edition > Install FactoryTalk
Historian Server.
The installation wizard appears.
If there are any software prerequisites missing from the
computer or services that must be stopped, they are listed in
red at the bottom of the installation wizard Welcome page.
Click Cancel, and then Finish to exit the wizard, install the
prerequisites and/or stop the services, and then start the
installation wizard again.
3. On the Welcome... page, click Next.
4. On the License Agreement page, read and accept the terms of
the license agreement, selecting the I accept... option.
5. Click Next.