Rockwell Automation FactoryTalk Historian SE 4.0 Installation and Configuration Guide - Manual (Page 121)

Troubleshooting FactoryTalk Historian Chapter 6
Rockwell Automation Publication HSE-IN025A-EN-E–September 2013 121
NOTE
You need administrator privileges to perform the steps described below.
TIP
If you prefer, you may manually (page 75) configure the firewall settings
described below.
To automatically configure Windows Firewall with WFCU:
1. Go to the computer on which you have the particular
Historian suite installed.
2. Check the location of the Common Files folder on the
computer for the 32-bit operating system. You will need it in
the command line.
3. Open the Command Prompt window.
4. Type the command provided in the table below.
For this FactoryTalk Historian suite: Run these commands:
Historian to Historian Interface %COMMONFILESFOLDERX86%\Rockwell\WFCU\wfcu.exe -I
"%COMMONFILESFOLDERX86%\Rockwell\WFCU\FTH2HInterface.wfcu"
Asset Framework %COMMONFILESFOLDERX86%\Rockwell\WFCU\wfcu.exe -I
"%COMMONFILESFOLDERX86%\Rockwell\WFCU\FTHistorianSEAF.wfcu"
Historian Server %COMMONFILESFOLDERX86%\Rockwell\WFCU\wfcu.exe -I
"%COMMONFILESFOLDERX86%\Rockwell\WFCU\FTHistorianSEServer.wfcu"
Live Data Interface %COMMONFILESFOLDERX86%\Rockwell\WFCU\wfcu.exe -I
"%COMMONFILESFOLDERX86%\Rockwell\WFCU\FTHistorianSELiveDataInterface.w
fcu" -s
The %COMMONFILESFOLDERX86% variable stands for
the location of the Common Files folder on the computer.
Example: If the Common Files folder is in the following
location:
C:\Program Files\Common Files\
The complete path to the command that you need to run for
the Historian to Historian Interface is:
Configuring Windows
Firewall with WFCU