Rockwell Automation FactoryTalk Historian SE 4.0 Installation and Configuration Guide - Manual (Page 176)

Appendix F Removing FactoryTalk Historian SE
176 Rockwell Automation Publication HSE-IN025A-EN-E–September 2013
Click OK to complete the removal process.
• If you are removing FactoryTalk Historian from a computer,
on which FactoryTalk Historian SE 3.0 has been previously
installed, the following message appears after you click Finish
in the removal wizard:
Click OK to complete the removal process.
• If you are removing FactoryTalk Historian from a computer,
on which you have upgraded FactoryTalk Historian SE 3.0 to
3.01, both messages described above will appear.
NOTE
The FactoryTalk Historian removal wizard does not remove the
components that are shared by other FactoryTalk products. If
you want to remove them as well, you need to do it manually
using Control Panel.