Rockwell Automation FactoryTalk Historian SE 4.0 Installation and Configuration Guide - Manual (Page 53)

Rockwell Automation Publication HSE-IN025A-EN-E–September 2013 53
Chapter 4
Post-Installation Tasks
In this chapter you will learn about the following tasks that you
should perform after installing FactoryTalk Historian SE:
• View the Historian server installation log file (page 53).
• Verify that Historian services are running (page 53).
• Verify that Historian server is updating data for default tags
(page 55).
• Manually create or upgrade the AF SQL database (page 55).
• Perform the MDB to AF synchronization (page 61).
• Verify the MDB to AF synchronization (page 61).
• Disable virus scanning (page 61).
You can open the installation log, fth_installer.log, directly from
the installation wizard. If you want to refer to it later, open it from
the following location:
C:\Program Files\Rockwell Software\FactoryTalk
Historian\Installation Manager\<Name of the Historian
suite>\FTHInstallerLogs\<Date and Time of the Installation>.
Use Historian Services in System Management Tools to view,
configure, start and stop Historian services for each connected
Historian server. The status of each service is updated every 30
seconds by default. You may change this refresh rate. You can also
view the status, errors, and thread details for services used by the
connected Historian server, and export a list of Historian services.
View the Installation Log File
Verify that Historian Services
are Running