Rockwell Automation FactoryTalk Historian SE 4.0 Installation and Configuration Guide - Manual (Page 167)

Rockwell Automation Publication HSE-IN025A-EN-E–September 2013 167
Appendix E
Upgrading FactoryTalk Historian SE
In this chapter you will learn about upgrade procedures for
individual suites of FactoryTalk Historian SE.
The upgrade procedure differs depending on the version of
FactoryTalk Historian SE you are currently using. See each
procedure for details.
NOTE
Before you upgrade any components of FactoryTalk Historian SE, refer to
the Release Notes for the up-to-date information on the upgrade
procedures.
NOTE
You need administrative rights to perform these steps.
The upgrade procedure differs depending on the version of
FactoryTalk Historian server and your FactoryTalk Historian suite
that you currently use:
• If you are using the Historian SE server in versions 2.10 or
2.20, you need first to migrate your server to FactoryTalk
Historian SE 3.01, and then upgrade it following the steps
listed below.
NOTE
For more information on the migration process, refer to the KB
article 491889
(https://rockwellautomation.custhelp.com/app/answers/detail/
a_id/491889) on the Rockwell Automation Knowledgebase site.
• If you are using the Historian SE server in versions 3.0 or 3.01,
follow the steps below.
Upgrading FactoryTalk
Historian Server