Rockwell Automation T6200 Compressor Anti-Surge and Capacity Controller - Manual (Page 100)

HMI-6200 Operator Interface
6-34
Downloading the Updated Application
After the adaptation of the pre-defined displays is completed, connect the development computer to the
controller operator interface via a direct HMI Crossover Ethernet cable or via the controllers’ Primary
Ethernet connection (T6200 rear termination panel, Ethernet 1). If the connection is made through the
Primary Ethernet at the controller termination panel, make sure that the T6200 control board(s) is
unplugged and that the connection from the termination panel is made direct to the development
computer using a standard Ethernet cable.
HMI-6200 operator interface Arrangement
Select the Miscellaneous Screen (click on the *** button on the Header of the operator interface
display) Log Off and press the CEViewSD (CE View Shutdown, grayed out before Log Off
confirmation) button on lower right area of the screen. The operator interface will exit the CE View
program and display a Remote Agent window.
- Remote Agent Window
The user needs to move the "Remote Agent" window down only if he cannot see the information that he
wants to see. Typically, this will be required in order to expose the “My Computer” and “T6200
Configuration” icons.
- Delete existing COMPR_~1 Folder: Double-click the My Computer icon and then double-click the
IPSM folder icon to access the COMPR_~1 folder. Click the COMPR_~1 folder and click File and
Delete. The “Confirm Folder Delete” pop-up window with the text “Are you sure you want to remove
the folder ‘COMPR_~1’and all its contents?” will appear. Press Yes and close the pop-up. The
COMPR_~1 folder will be deleted. Close the window. The Remote Agent window (as it was previously
positioned) will appear.
FIGURE 6-34
Button
Log On/Off and
CEViewSD on
Misc *** Screen