Rockwell Automation T6200 Compressor Anti-Surge and Capacity Controller - Manual (Page 101)

HMI-6200 Operator Interface
6-35
Development Computer Arrangement
Make sure that the operator interface is properly connected to the development computer.
Network TCP/IP Properties Adaptation
Setting > Control Panel > Network. You will need to change the IP address on the development
computer only if the first three digits of the development computer's IP address do not exactly match the
first three digits of the Operator Interface's IP address. By default, the Operator Interface will come up
with the IP address of 16.1.0.21.
Execution Environment
Open the Execution Environment window (click on the Execution Environment icon on the Web Studio
Execution Toolbar, or select Execution Environment from the Project menu).
- Target Tab: Click on the Network IP radio button. Enter the IP address of the Operator Interface
which is displayed in the title bar of the “Remote Agent” window on the Operator Interface. Make sure
that the first three digits of the IP address of the Development Computer exactly match the first three
FIGURE 6-36
Execution Environment
Target Tab
Connect/Disconnect
FIGURE 6-35
Network Window
TCP/IP Properties
IP address