Rockwell Automation T6200 Compressor Anti-Surge and Capacity Controller - Manual (Page 31)

Hardware Installation/Maintenance
3-9
Input/Output Hardware Configuration
There are several different ways the hardware can be configured for each input/output. Refer to
Section Two Input/Output Circuit Description for details on each configuration. The different
configurations are achieved by the placement of jumpers (shorting bars) on a multi-pin headers located
on the printed circuit board. Each channel has a separate header and can be configured independently.
To access the jumpers:
ƒ
Unplug the optional front panel Operator Interface
ƒ
Carefully slide the printed circuit board out the front of the chassis.
The Controller contains parts susceptible to damage by electrostatic
discharge. Normal precautions should be taken to avoid high static
voltages.
When facing the component side of the printed circuit board with the LEDs on the left, the
headers/jumpers will be at the right Pin one on the headers will be as shown in the illustrations. Pin one
also has a square pad on the circuit side of the printed circuit board. Refer to Figure 3-7 for T6200C.
Refer to Figure 3-11 for T6200D.
The headers may vary from input/output group to group. All the headers are oriented the same way
within one group. A group is where a`ll consecutive inputs/outputs have the same configuration
options. For example, channels one through eight are in the same group.
FIGURE 3-7.
T6200C Control
Board
CAUTION