Rockwell Automation T6200 Compressor Anti-Surge and Capacity Controller - Manual (Page 26)

Hardware Installation/Maintenance
3-4
ƒ The control boards slide out the front of the unit.
ƒ To ensure a proper viewing angle, the Controller should be installed approximately
64 inches (1.6 m) above the floor.
ƒ Outdoor installation is not recommended. However, for outdoor installations, the
face of the Controller should be shielded from direct sunlight, since bright light produces a
poor display contrast.
T6200 Controller Mounting
T6200 Controller Mounting
Figure 3-1 provides mounting dimensions for the T6200 Controller. Dimensions are shown in inches
(mm).
ƒ Remove Operator Interface by pushing up and pulling out at the bottom. Disconnect cable
from Operator Interface
ƒ Use the two Phillips head screws and clamps to mount the T6200 Controller in the user’s
panel.
ƒ When the T6200 Controller is positioned properly, hand-tighten both clamps in place. Note:
Do not exceed 15 in-lbs (17 cm-kgs) of torque on panel clamp screws.
The panel cut-out dimensions, as well as the Operator Interface front outline dimensions are shown in
Figure 3-2. The T6200 Controller would normally be mounted in a vertical position.
Figure 3-3 provides mounting dimensions for the optional Remote I/O Termination Panel. The I/O
cable that connects the T6200 Controller to the Remote I/O Termination Panel is 6 ft. (2m) long.
Dimensions are shown in inches (mm). The Remote I/O Termination Panel can be snapped onto a user
supplied standard 35 mm DIN rail.
T6200R Subrack Mounting
Each T6200R Subrack Housing accommodates up to six redundant T6200 Controllers. The subrack
may also include two power supplies, Operator Interface, and two Ethernet hubs. Refer to Figure 3-4
for T6200R Subrack mounting dimensions. The subrack should be mounted in a EIA standard 19 inch
rack. Refer to Section Nine Specifications for more detailed physical dimensions.