Rockwell Automation T6200 Compressor Anti-Surge and Capacity Controller - Manual (Page 154)

Configuration
8-34
T6200 – Project Build
Project Compilation : On the configurator Main Window press the button to re-build
the project if any changes are made to the configuration.
The project must be built (compiled) before it is converted to the MLP language file and then
downloaded to the T6200 controller via the OPC server.
The compiler runs in a separate window where compiling messages are reported. If compiling
errors occur, just double click on an error message for opening the corresponding program at the
appropriate location. The compiler also provide commands to:
"Clean" the project: This command deletes all files created during the last compiling.
Note: When basic configuration changes are made to applications, it is recommended to “Clean” the
project and then press the project compilation button again.
Project with compilation errors:
Project without compilation errors:
Refer to OPC Server Configuration File Interface for information on
downloading the MLP protocol file to the T6200 controller.
FIGURE 8-24
Compilation
Message:
Errors detected
FIGURE 8-25
Compilation
Message:
No Errors