Rockwell Automation T6200 Compressor Anti-Surge and Capacity Controller - Manual (Page 58)

Software Installation
4-8
Primary Control Board Ethernet Address
Backup Control Board Ethernet Address
UC254,00:08:9A:D2:05:02,00:0D:9A:D2:05:02,
UC255,00:08:9A:D2:06:02,00:0D:9A:D2:06:02,
PRI ID from I/O Backplane
BAK ID from I/O Backplane
T6200 Controller Name
The strings are separated by a comma. The first string is the name for the T6200 Controller. The
second string is the Ethernet address for the primary control board and the third string is the Ethernet
address for the backup. Make sure there is a comma at the end of each line. There can be only one
Controller per line. Refer to Figure 4-12. The Controller/s listed in this file will be the only one/s that
the MICON OPC Server will communicate with at runtime.
The T6200 Controller name must be a unique name and should have from one to 16 alphanumeric, dash (-
), and/or underscore (_) characters. The name cannot contain spaces (blanks) or other symbols. The first
character of a name cannot be a dash or number. Both upper and lower case letters are accepted.
The PRI ID and BAK ID numbers on the T6200 Controller I/O Backplane is used to build the Ethernet
addresses. Refer to Figure 4-13. Add “00:” in front of each number, add “:” between every other digit,
and add “:02,” to the end.
Figure 4-12
Figure 4-13
devlist.txt – Notepad
Window
T6200 PRI ID and
BAK ID