Rockwell Automation T6200 Compressor Anti-Surge and Capacity Controller - Manual (Page 30)

Hardware Installation/Maintenance
3-8
T6200R Subrack Electrical Power Connection
Once the T6200R Subrack is mounted, plug the included external power supply’s DC power cord into
the matching power jack on each of the Ethernet Hub’s rear panel. The Ethernet Hub shelf may be
removed to connect the power. Plug each of the power supply’s transformers into an AC receptacle that
is six feet (two meters) or less away. The green “Pwr” LED should light up.
Refer to the guidelines in T6200 Controller Electrical Power Wiring above and Figure
3-6 and connect AC power wiring to each of the 26 Vdc Power Supplies.
The 26 Vdc power to the T6200 Controllers and Operator Interface is usually prewired as shown in
Figure 3-6.
Internal Power
Distribution
FIGURE 3-5
Figure 3-6
T6200R Subrack
Power Wiring