Rockwell Automation T6200 Compressor Anti-Surge and Capacity Controller - Manual (Page 166)

Configuration
8-46
Halt and Delete a Controller File:
Click on Halt and confirm that you want to halt the processing of the file (click “Yes” on the
confirm pop-up). The Status window (see Status, following left-side display) will advise that
“Tags from this controller have NOT been removed from the OPC Server’s database. Do NOT
serve tags from this controller until you re-execute the same or an equivalent file on this
controller.”
Click on Delete and confirm that you want to delete the processing of the file (click “Yes” on the
confirm pop-up). The Status window (see Status, following right-side display) will advise “Do
NOT serve tags from this controller until you re-execute the same or an equivalent file on this
controller. and, Deleted File_________ command successful”.
Note for applications with basic configuration file changes (deleted file is completely different file than the
file to be downloaded): After a file is deleted and before proceeding with Download of a new file, it is
recommended to clear the memory of the controller board. This is accomplished by removing and re-seating
the control board(s) and then immediately (during the first 3 seconds) depressing the Push to Activate button
for two (2) seconds or more.
FIGURE 8-29
Configuration File
Interface
Left-Side Window:
Halt Controller File
Right-Side Window:
Delete Controller File