Rockwell Automation T6200 Compressor Anti-Surge and Capacity Controller - Manual (Page 102)

HMI-6200 Operator Interface
6-36
digits of the Operator Interface's IP address. Then press Connect. The Status line will confirm the
connection as shown above.
Note: After completion of application downloading, do not forget to return the radio button selection
from Network IP to Local.
- Application Tab: Once the connection is confirmed, select the Application Tab and press the Send To
Target button. This command sends the new/revised application to the HMI-6200 operator interface.
Make sure that the destination folder has "\IPSM\Compr_~1" as its value. If you have created this folder
on the Operator Interface, then make sure you delete it before clicking on the "Send to Target" button.
-Application Update Completion: The Status line will confirm that the Application was updated with
success (see below).
Note: After completion of application downloading, do not forget to select the Target tab, press
Disconnect and to return the radio button selection from Network IP to Local.
Running the Application
After the new/revised application has been successfully downloaded to the HMI-6200 operator
interface, lunch it by pressing the Start button on the Remote Agent window.
FIGURE 6-37
Execution Environment
Application Tab
Send to Target
HMI-6200 Operator
Interface
Sending to Target
Pop-up below
Status
Application updated
below