Rockwell Automation T6200 Compressor Anti-Surge and Capacity Controller - Manual (Page 45)

Hardware Installation/Maintenance
3-23
T6200R Subrack Ethernet
The Ethernet Hubs on the T6200R Subrack are usually connected as shown in Figure 3-17.
If the workstation is not part of an existing network, connect the workstation to port eight on the
hubs. Set the Up-Link switch to “Normal”.
To connect the hubs to an existing network; set the Up-Link switch to “Up-Link” and connect
existing network to port eight.
The Operator Interface is usually connected to port seven on Ethernet 1 Hub.
FIGURE 3-18
Non-Redundant
Network with
Single Dual T6200
Controller and
Single
Workstation
FIGURE 3-19
Redundant
Network with
Multiple
Dual T6200
Controller and
Redundant
Workstations