Metrohm tiamo 2.1 Manual - Manual (Page 1004)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
990 ￭￭￭￭￭￭￭￭ tiamo 2.1
Stop volume
Volume of auxiliary solution (e.g. buffer) that is to be added to the sample
before the first standard addition.
Range 0.0 ... 9999.9 mL
Default value 100.0 mL
Addition solution
Note
Displayed only for Solution = not defined.
Concentration
Concentration of addition solution.
Range 0.001 ... 999999.999
Default value 1.000
Device
Concentration unit of addition solution.
Selection mol/L | mmol/L | µmol/L | ppm | g/L | mg/L |
µg/L | mg/mL | µg/mL | % | mEq/L
Default value ppm
Control parameters
Dosing rate
Speed at which the volume increments are added.
Selection slow | medium | fast
Default value fast
Delta U
Potential difference that is to be achieved by a standard addition.
Range 1 ... 999 mV
Default value 10 mV
5.6.4.16.4 STDADD auto - Measuring parameters
Tab: Method ▶ STDADD ▶ Properties... ▶ Measuring parameters
Command name
Name of the command.
Input 25 characters