Metrohm tiamo 2.1 Manual - Manual (Page 888)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
874 ￭￭￭￭￭￭￭￭ tiamo 2.1
Identification Description
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value x (1…3) for the last measuring point
on the measuring point list
.LP.EXx External value x (1…3) for the last measuring point on
the measuring point list
.LP.MEA Measured value for the last measuring point in the
measuring point list in the unit of the measured value
.LP.TEM Temperature for the last measuring point of the meas-
uring point list in °C
.LP.TIM Time in s until the last measuring point in the measuring
point list is reached
.MA.MEA Maximum measured value (U
ind
) in mV
.MA.TEM Temperature for the maximum measured value in °C
.MA.TIM Time in s until the maximum measured value is reached
.MI.MEA Minimum measured value (U
ind
) in mV
.MI.TEM Temperature with minimum measured value in °C
.MI.TIM Time for the minimum measured value in s
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in the measuring point list
.SLO Electrode slope of the sensor used for the command (in
mV for ISE sensors)
.STY Type of stop with which the command was stopped:
1 = normal;0 = manual or after error
5.6.4.3.2 MEAS U - General/Hardware
Tab: Method ▶ MEAS U ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters