Metrohm tiamo 2.1 Manual - Manual (Page 184)

3.8 Subwindow Live display ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
170 ￭￭￭￭￭￭￭￭ tiamo 2.1
MEAS TC Cond
Selection
off | Measured value | time | dMW/dt | Calcula-
ted 1...3 | External 1...3
Default value off
MEAS Opt
Selection
off | Measured value | time | Intensity | Trans-
mission | Saturated pixels
Default value off
DOS
Selection
off | Measured value | time | Temperature | Vol-
ume | dV/dt | Calculated 1...3 | External 1...3
Default value off
Curve display
on | off (Default value: off)
If this option is enabled the curves required are displayed in the subwindow
Live display.
x axis
Selection of the quantity shown on the x axis.
DET
Selection
Volume | Measured value | time | Temperature
| ERC | Calculated 1…3 | External 1…3
Default value Volume
MET
Selection
Volume | Measured value | time | Temperature
| dMW | Calculated 1…3 | External 1…3
Default value Volume
SET
Selection
time | Measured value | Temperature | Volume
| dV/dt | Calculated 1…3 | External 1…3
Default value time
KFT
Selection
time | Measured value | Temperature | Volume
| dV/dt | Calculated 1…3 | External 1…3
Default value time