Metrohm tiamo 2.1 Manual User Manual
Page 278
4.4 Templates
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
264
￭￭￭￭￭￭￭￭
tiamo 2.1
<adcSerial val="" />
Serial number of measuring input.
<tempSensorType val="" />
Type of temperature sensor (Pt 1000 or NTC).
<tempSensorValue25 val="" />
Nominal resistance of connected NTC sensor.
<tempSensorSlope val="" />
Material constant of the NTC resistance referred to meas-
uring the resistance at 25 °C and 50 °C.
</measInput>
– <sensorData>
Data on sensor.
<sensorName val="" />
Sensor name.
<sensorType val="" />
Sensor type.
<sensorOrderNo val="" />
Order number of sensor.
<sensorSerialNo val="" />
Serial number of sensor.
<sensorInitDate val="" />
Date on which the sensor was used for the first time.
<sensorCellConst val="" />
Cell constant of the conductivity sensor.
<sensorSlope val="" />
Slope of the sensor.
<sensorPh0 val="" />
Electrode zero point of the pH sensor.
<sensorIonVa val="" />
Ion (valency) of the ISE sensor.
<sensorE0 val="" />
Electrode zero point of the sensor.
<sensorC val="" />
Blank value of the ISE sensor.
<sensorCalTemp val="" />
Calibration temperature.
<sensorCalDate val="" />
Calibration date.
<sensorCalMethod val="" />
Calibration method.
<sensorCalMeasInput val="" />
Measuring input at calibration.
</sensorData>
</Sensor>
</Device>
– <CalibData>
Calibration data
<sensorName val="" />
Sensor name.
<sensorType val="" />
Sensor type.
<sensorSlope val="" />
Slope of the sensor.
<sensorPh0 val="" />
Electrode zero point of the pH sensor.
<sensorIonVa val="" />
Ion (valency) of the ISE sensor.
<sensorE0 val="" />
Electrode zero point of the sensor.