Metrohm tiamo 2.1 Manual - Manual (Page 978)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
964 ￭￭￭￭￭￭￭￭ tiamo 2.1
Identification Description
.LP.MEA Measured value for the last measuring point in the
measuring point list in the unit of the measured value
.LP.TEM Temperature for the last measuring point of the meas-
uring point list in °C
.LP.TIM Time in s until the last measuring point in the measuring
point list is reached
.LP.TRN Transmission of the last measuring point of the meas-
uring point list in %
.MA{#}.[MEA] Maximum measured value in the unit of the measured
value
.MA{#}.CNT Intensity for maximum measured value in counts
.MA{#}.TEM Temperature for minimum measured value in °C
.MA{#}.TIM Time for the minimum measured value in s
.MA{#}.TRN Transmission for maximum measured value in %
.MI{#}.[MEA] Minimum measured value in the unit of the measured
value
.MI{#}.CNT Intensity for minimum measured value in counts
.MI{#}.TEM Temperature for minimum measured value in °C
.MI{#}.TIM Time for the minimum measured value in s
.MI{#}.TRN Transmission for minimum measured value in %
.NMP Number of measuring points in the measuring point list
.STY Type of stop with which the command was stopped:
1 = normal;0 = manual or after error
5.6.4.13.2 MEAS Opt - General/Hardware
Tab: Method ▶ MEAS Opt ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the device are defined on this tab.