Metrohm tiamo 2.1 Manual - Manual (Page 796)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
782 ￭￭￭￭￭￭￭￭ tiamo 2.1
5.6.3.6.8 KFC - Additional evaluations
Tab: Method ▶ KFC ▶ Properties... ▶ Additional evaluations
Command name
Name of the command.
Input 25 characters
The following additional method for evaluation of the titration curves can
be activated and defined on this tab:
Fix endpoint evaluation
Fix endpoint evaluation
on | off (Default value: off)
If this option is enabled, then the associated values for the other measured
quantities will be interpolated with a fixed measured quantity (measured
value, time or water) for the fixed endpoint from the measuring point list.
Moves the selected line up (changes the sequence).
Moves the selected line down (changes the sequence).
[New]
Opens the dialog window Fix endpoint evaluation # to enter a new fixed
endpoint (see Chapter 5.6.3.6.10, page 784).
[Properties]
Opens the dialog window Fix endpoint evaluation # to edit the fixed
endpoint selected in the table (see Chapter 5.6.3.6.10, page 784).
[Delete]
Deletes the selected line.
5.6.3.6.9 KFC - Additional measured values
Tab: Method ▶ KFC ▶ Properties... ▶ Additional measured values
Command name
Name of the command.
Input 25 characters
A maximum of 6 additional measured values can be defined on this tab
which can then be saved together in additional measured value columns
with the measured values present in the default settings: