Metrohm tiamo 2.1 Manual - Manual (Page 710)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
696 ￭￭￭￭￭￭￭￭ tiamo 2.1
Titrino
Range
0 ... 999 s
Default value 10 s
Selection inf.
Stop time
The titration is stopped if the stop time defined here has elapsed since the
start of the titration. This parameter is only shown for Stop criterion =
time and Delay time = inf.
Titrino
Range
0 ... 999999 s
Selection off
Default value off
Endpoint 2
Note
Is activated only for EP1 with ≠ off.
on | off (Default value: off)
Switching endpoint 2 on/off. If this is deactivated all following parameters
are not visible.
EP2 with
Measured value for the second endpoint.
Titrando, 855
Range
-2000.0 ... 2000.0 mV
Selection off
Default value off
Titrino
Range
-2000 ... 2000
Selection off
Default value off
For additional parameters for Endpoint 2, see Endpoint 1.