Metrohm tiamo 2.1 Manual - Manual (Page 1378)

7.11 814/815 USB Sample Processor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1364 ￭￭￭￭￭￭￭￭ tiamo 2.1
This button is only displayed with devices that have their own firmware. It
is only active if the device has an old program version not supported by
tiamo and which can be updated by tiamo itself.
Device serial number
Shows the serial number of the device.
Start-up
Shows the date on which the device was automatically added to the device
table.
Data storage under legal control
Indicates whether the balance has its own calibratable data memory.
Only visible and editable with Sartorius balances.
Selection
on | off
Default value off
Remarks
Remarks about the device.
Input 1000 characters
Default value empty
7.11.3 Properties - Tower #
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Tower #
On the tab Tower the properties of the tower and of the robotic arm con-
nected to are displayed.
Tower parameters
Max. stroke path
Entry of the lowest permitted lift position. A lift height of 0 mm corresponds
to the "Home position", i.e. the lift is moved right to the top.
Range 0 ... 235 mm
Default value 235 mm
Min. beaker radius
Definition of the minimum radius which the beakers used on the rack must
have. If the lift is moved to the work position the beaker radii defined in
Rack table(see Chapter 6.10.2.1, page 1296) for general Sample posi-
tions(see Chapter 6.10.3.2, page 1299) and Special beakers(see Chapter
6.10.3.4, page 1301) will be compared with the Min. beaker radius. If