Cabletron Systems CSX1000 - Manual (Page 121)

Workgroup Remote Access Switch 121
C ONFIGURING B ASIC IP R OUTING
IP Network Interfaces
In the previous graphic, the WAN network interface 1.1.1.1 on SITE1 is used to connect to a
dedicated line and an ISDN line. You need to specify to which remote device, either SITE2 or SITE3,
SITE1 should exchange RIP packets. If it is necessary to run the RIP between SITE1 and SITE3 as
well as between SITE1 and SITE2, then another WAN network interface (for example, 2.1.1.1 on
SITE1 and 2.1.1.3 on SITE3) must be configured, as illustrated:
1.1.1.2
1.1.1.1
1.1.1.3
Dedicated
Connection
ISDN
CSX1200
CSX5500
CSX1200
Z
POWER SERVICE TX RX 10BASE - T LAN B-CHANNELS E1 ONLY
B2 B4 B6 B8 B26 B28 B22 B24 B18 B20 B14 B16 B10 B12 B30 L1
B1 B3 B5 B7 B25 B27 B21 B23 B17 B19 B13 B15 B9 B11 B29 B31 E1 D T1 D
POWER SERVICE TX RX 10BASE - T LAN B-CHANNELS E1 ONLY
B2 B4 B6 B8 B26 B28 B22 B24 B18 B20 B14 B16 B10 B12 B30 L1
B1 B3 B5 B7 B25 B27 B21 B23 B17 B19 B13 B15 B9 B11 B29 B31 E1 D T1 D
1.1.1.2
1.1.1.1
Dedicated
Connection
ISDN
2.1.1.1
2.1.1.3
Z
CSX1200
CSX1200
CSX5500
POWER SERVICE TX RX 10BASE - T LAN B-CHANNELS E1 ONLY
B2 B4 B6 B8 B26 B28 B22 B24 B18 B20 B14 B16 B10 B12 B30 L1 B1 B3 B5 B7 B25 B27 B21 B23 B17 B19 B13 B15 B9 B11 B29 B31 E1 D T1 D
POWER SERVICE TX RX 10BASE - T LAN B-CHANNELS E1 ONLY
B2 B4 B6 B8 B26 B28 B22 B24 B18 B20 B14 B16 B10 B12 B30 L1 B1 B3 B5 B7 B25 B27 B21 B23 B17 B19 B13 B15 B9 B11 B29 B31 E1 D T1 D
"SITE1"
"SITE2"
"SITE3"