Cabletron Systems CSX1000 - Manual (Page 181)

Workgroup Remote Access Switch 181
C ONFIGURING O FF - NODE S ERVER I NFORMATION
RADIUS Authentication Server
U SING CFGEDIT
1. Select option (2), RADIUS from the Off-node Server Information menu. If you need guidance
to find this menu, refer to the instructions provided in the
VRA Manager Authentication Server
configuration section. The following screen will be displayed:
2. Select (1) Primary Server to enter the following information:
a.
IP address of the Authentication Server
b. shared secret between the CyberSWITCH and Authentication Server
c. UDP port number used by the Authentication Server
3. Optional: configure a secondary RADIUS Server with selection (2). In the event that the
primary server does not respond to system requests, the secondary server will be queried for
device authentication information. The address and port number of the Secondary RADIUS
Server must not be the same as the Primary RADIUS Server.
4. Select Miscellaneous Information to finish the configuration. Specify the number of access request
retries that the system will send to the Authentication Server, as well as the time between
retries.
U SING M ANAGE M ODE C OMMANDS
radius
Displays the current RADIUS server configuration data.
radius change
Allows you to change the current RADIUS server configuration data. After entering the
radius change command, you will be prompted for the configuration elements you want to
change.
RADIUS Authentication Server Menu:
Primary Server
IP Address is 128.111.011.001
Shared Secret is "SHAREDSECRET1234"
UDP Port Number is 5800
Secondary Server
is Not Configured
Access Request Retry
Number of Access Retries is 5
Time between Retries is 2 seconds
RADIUS Server Options:
1) Primary (Master) Server
2) Secondary (Slave) Server
3) Miscellaneous Information
Select function from above or <RET> for previous menu: