Cabletron Systems CSX1000 - Manual (Page 463)

Workgroup Remote Access Switch 463
S YSTEM M ESSAGES
System Message Summary
Manage Mode updates have been successfully committed
The above message indicates that the Dynamic Management commit command was successfully
completed.
Manual intervention required: please replace LAN card
Older versions of the Ethernet adapter may need to be updated or replaced to run Release 2.3 or
greater. If the above message appears in your system log messages, you will need to replace your
Ethernet adapter.
Manual restart initiated on DM board in slot <slot # >
There was an attempt to restart the specified Digital Modem with the
modem restart command.
Check subsequent log messages to verify the command was successful.
Maximum call charges exceeded for month
The configured maximum for monthly call charges has been exceeded.
Maximum call minutes per day limit (x) has been reached
The described limit has been exceeded. The next log message will indicate whether calls will still
be allowed or not.
Maximum call minutes per month limit (x) has been reached
The described limit has been exceeded. The next log message will indicate whether calls will still
be allowed or not.
Maximum calls per day limit (x) has been reached
The described limit has been exceeded. The next log message will indicate whether calls will still
be allowed or not.
Maximum calls per month limit (x) has been reached
The described limit has been exceeded. The next log message will indicate whether calls will still
be allowed or not.
MCP detected channel failure: <channel number>
A link has failed for some abnormal reason and the indicated channel has been disconnected. This
message is generally preceded by another message which indicates the underlying protocol. Refer
to that message. If this does not pinpoint the problem, check the application on the remote device
to see if it is working correctly.
Memory Access Timeout
This indicates a TDM bus connector failure that is specific to the TDM bus connecting a primary
rate and a basic rate adapter. Ensure that the TDM bus has been correctly connected to the two
adapters. If problem continues, contact your Distributor or Customer Support.
MEMORY LIMITED - <x> COMPRESSION connections available
Where “x” is equal to the number of connections that can be supported. There is not enough
memory available to support the number of compression connections being allocated. You may
want to purchase more memory for your system. Contact your Distributor or Customer Support.
Mild congestion CLLM received for DLCI <dlci index>
A CLLM message was received indicating mild congestion may be expected on the PVC associated
with the indicated DLCI.