Cabletron Systems CSX1000 - Manual (Page 453)

Workgroup Remote Access Switch 453
S YSTEM M ESSAGES
System Message Summary
Invalid CLLM received on Access <access index>
An invalid CLLM message was received on the indicated Frame Relay Access. The message had
either missing elements or invalid contents.
Invalid LAN Adapter identifier
The system has detected invalid LAN adapter hardware. Check for proper LAN adapter
configuration and hardware installation.
Invalid Password <password> given
The remote Combinet sent a password that did not match any device table entries. This most likely
is due to a configuration error. Check the configuration, and change the password.
Invalid SERIAL.001 file present, file is ignored.
Contact your Distributor or Customer Support.
Invalid SERIAL.BIN file present, system booting in minimal mode.
Contact your Distributor or Customer Support.
Invalid serial number in SERIAL.001, file is ignored.
Contact your Distributor or Customer Support.
Invalid serial number in SERIAL.BIN file, system booting in minimal mode.
Contact your Distributor or Customer Support.
IP Error from ESP datagram - discarded
An error occurred within the IP forwarding logic which make it impossible to send this datagram.
[IP] Invalid Device Info. Device is not IP callable <device name>
An IP packet could not be forwarded to a remote network because the next-hop device for that
network is not configured as IP Callable. The CyberSWITCH returns a network unreachable message
to the sender.
[IP] x.x.x.x not added to the pool: Invalid IP address
A failure was encountered by the IP subsystem during initialization processing. IP made an
unsuccessful attempt to add a “static” address to the IP Address Pool. The IP address being added
did not match any of the configured IP network interfaces.
[IP] x.x.x.x not added to the pool: Invalid Device Id
A failure was encountered by the IP subsystem during initialization processing. IP made an
unsuccessful attempt to add a “static” address to the IP Address Pool. The ID supplied by the IP
subsystem was invalid. Contact your Distributor or Customer Support.
[IP] x.x.x.x not added to the pool: IP Address Pool Full
A failure was encountered by the IP subsystem during initialization processing. IP made an
unsuccessful attempt to add a “static” address to the IP Address Pool. The IP Address Pool was
already full.
[IP] x.x.x.x not added to the pool: Unknown error (y)
A failure was encountered by the IP subsystem during initialization processing. IP made an
unsuccessful attempt to add a “static” address to the IP Address Pool. An unknown error code was
returned by the IP Address Pool Manager. Contact your Distributor or Customer Support.