Cabletron Systems CSX1000 - Manual (Page 461)

Workgroup Remote Access Switch 461
S YSTEM M ESSAGES
System Message Summary
LAN Adapter out of receive buffers for the WAN port
The LAN adapter is temporarily out of the buffers it uses to receive packets from the WAN port.
This condition should clear itself. If the condition persists, contact your Distributor or Customer
Support.
LAN Adapter port <port # > transmit error <error code>, check connection
The LAN adapter detected an error transmitting a frame on the indicated port. Check that the LAN
is properly connected to the adapter and that the LAN is properly terminated.
LAN Adapter Reset
This is an initialization message. The Ethernet adapter has been reset as part of the adapter
initialization sequence.
LAN Adapter Response Timeout
The system expected a command response from the adapter that it did not receive. Check for
proper hardware installation.
LAN Adapter ROM version # # # # # # # # .# # # # # # # # .# # # # # # # #
The ROM version in the Ethernet adapter is indicated.
LAN Adapter software version conflict
When software is downloaded onto the Ethernet adapter, its software version is compared to the
version of software running on the host’s main processor. If the versions do not match, this message
is posted. The upgrade did not work properly; contact your Distributor or Customer Support.
LAN Adapter System resource error
LAN Adapter hardware failure detected. If the problem persists, replace your LAN adapter.
LAN Init Error
LAN connection failure. Initialization failure detected by the LAN packet forwarding component
in the system.
LAN Port <port # > detected a transceiver problem
The system detected a LAN connection problem on the indicated port. Check for proper LAN
connection installation.
LAN Port <port # > detected jabber condition <n> times(s)
A “jabber” condition or an Ethernet frame larger than the maximum legal length has been received.
This message is usually displayed if there is a malfunctioning transceiver or a malfunctioning
Ethernet device on the LAN. This message is not displayed for every error condition. It appears
after 24 hours since the last message was displayed. This message provides the LAN port # in
question, and the number of times <n> the jabber condition has been detected.
LAN Port <port # > detected open LAN media
The system detected a problem with the physical LAN on the indicated port. The LAN is not
properly terminated or the LAN is not fully connected to the system. Check for proper LAN
installation.