Cabletron Systems CSX1000 - Manual (Page 446)

USER’S GUIDE
446 CyberSWITCH
EDS-DES Board Absent
EDS-FEAL Board Absent
The encryption board is either physically not in the backplane, or the dip switches on the board are
set incorrectly. Check for the board; verify the
switch settings .
Error closing file ’s’
The WAN card initialization subsystem encountered an error while downloading a WAN card. The
system could not close the download disk file indicated. Restart the system. If the error continues,
Contact your Distributor or Customer Support.
Error closing file <file name>, slot <slot # >
Error closing password data file
If seen repeatedly, the above messages indicate a problem with your hard drive. Please contact
your Distributor or Customer Support.
Error downloading bootstrap program to adapter # ’x’
The WAN card initialization subsystem encountered an error on the indicated adapter while
downloading the bootstrap program. Restart the system and review the configuration for the
adapter. If the problem persists, the indicated adapter card may be faulty; contact your Distributor
or Customer Support.
Error downloading operational software to adapter ’x’
The WAN card initialization subsystem encountered an error on the indicated adapter while
downloading operational software. Restart the system and review the configuration for the
adapter. If the problem persists, the indicated adapter card may be faulty and you should contact
your Distributor or Customer Support.
Error during channel initialization Access <access index>
An error has occurred during the initialization of the indicated Frame Relay Access, or port. Likely
cause of this entry is that the system has run out of memory. Contact your Distributor or Customer
Support.
Error during port initialization Access <access index>
An error has occurred during the initialization of the indicated Frame Relay Access, or port. Likely
cause of this entry is that the system has run out of memory. Contact your Distributor or Customer
Support.
Error during PVC initialization Access <access index>
An error has occurred during the initialization of the indicated. Likely cause of this entry is that the
system has run out of memory. Contact your Distributor or Customer Support.
Error initializing WAN card: <WAN card Id>
The system could not initialize the specified WAN card during system initialization. Check the
WAN card installation and configuration. If the error continues, report the problem.
Error in last LMI message detected Error <error code>
An error was detected in the last LMI message forwarded by the network. The error is identified
by the indicated error code.
Error loading WAN board, data verify error: adapter ’x’
The WAN card initialization subsystem encountered an error during download verification. The
specified adapter card may be faulty. Contact your Distributor or Customer Support.