Spanning tree protocol, Configuring spanning tree protocol, Spanning tree protocol configuration elements – Cabletron Systems CSX1000 User Manual
Page 220: Bridge mode of operation, Configuring the bridge mode of operation, Bridge mode of operation configuration elements, Spanning tree protocol 220, Bridge mode of operation 220, Mode of operation
USER’S GUIDE
220 CyberSWITCH
9.
Enable Bridging.
10. Enable Make Calls for bridge data. You must have already configured the device’s phone number
(Step 6) before the system allows you to enable this feature.
Return to the Current Device Table. The system notifies you of proper configuration for your new
device, or informs you of what you are missing.
S
PANNING
T
REE
P
ROTOCOL
C
ONFIGURING
S
PANNING
T
REE
P
ROTOCOL
U
SING
CFGEDIT
1.
Select Spanning Tree from the Bridging menu.
2.
Enter the bridge age time.
S
PANNING
T
REE
P
ROTOCOL
C
ONFIGURATION
E
LEMENTS
B
RIDGE
A
GE
T
IME
If you are using bridge dial out, you may wish to increase this value to prevent the connection from
aging out before the call is made.
B
RIDGE
M
ODE
OF
O
PERATION
C
ONFIGURING
THE
B
RIDGE
M
ODE
OF
O
PERATION
U
SING
CFGEDIT
1.
Select Mode of Operation from the Bridging menu.
2.
Select the bridge mode of operation. The unrestricted bridge mode is the default.
B
RIDGE
M
ODE
OF
O
PERATION
C
ONFIGURATION
E
LEMENTS
B
RIDGE
M
ODE
The forwarding method that the bridge will use to distribute LAN packets to the remote sites and
to the LAN ports of the CyberSWITCH. The default value is unrestricted bridging.
Device Bridging: (Device = "DAN")
1) IP (sub)network number None
2) Bridging ENABLED
3) Make Calls for bridge data None
4) IPX Network Number None
5) IPX Spoofing Options
Id of option to change or press <RET> for previous menu? 3